On the client machine, follow the networking steps thus far, but also route internet traffic to the box using: At this point, it is advisable to set up a second machine to act as a client – convince a housemate, thats what I did: This prevents an error from appearing on my system, setting the console font to be default as before. If the network is working thus far, the next thing to do is to enable WEP. Search Search this site: Again, replace eth0 on these lines with wlan0.
|Date Added:||3 July 2014|
|File Size:||62.97 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Hopefully soon Linus will include it in the big one Lionel Dricot ploum wrote on. However this is more than enough for detecting the presence of the majority of APs!
Actually the Atmel at76ca chips are not supported atmel at76ca the in-kernel atmel atmel at76ca. I tried both out with little success – neither support monitor mode impossible due to the device’s firmware.
Change it to your IP and replace eth0 with wlan0. The source code is easily readable here too. If you happen atmel at76ca have an Atmel-based adapter and wish to atel it under Linux, head to the: Uncomment and edit your essid and mode to be as above and also pick a channel number. An alternative driver; many people says this driver works better than the other. To configure the firewall and packet forwarding, issue the following commands at the terminal comments beginning with are for reference only: It now conforms to the interface required to use sniffing apps such as Kismet and Ethereal so they work nicely with minimum fuss.
If it works then bingo! Functionality Hardware Software Screenshots Gallery.
However this is atmel at76ca than enough for detecting the presence of the majority of APs! I started hacking away ar76ca the BerliOS drivers and added: Now configure the network interface to have an IP address.
The support atmel at76ca be obtained with one of these two drivers: Now we need to run etc-update. This may seem laborious, but is better than gnome not booting and having to add to all of the config files again [like I had to: At this point, it is advisable to set up a second machine to act as a client – convince a housemate, thats what I aatmel Ensure that you have the wireless tools installed by doing an emerge wireless-tools.
With monitor mode, I’d be able to point the woktenna around and pick up the beacon frames of distant APs. You can then see if the name is getting resolved but you still won’t get a response yet.
Make it starts at boot with: I found two drivers available for this device: This will configure the wireless card. Hopefully soon Linus will include it in the big one To post a comment you must atmel at76ca in. Get the latest version of the BerliOS Atmel driver by executing emerge at76ca. I get an error saying no interface module has been loaded when starting the wireless card!
Now to make the client resolve hostnames through the box.
Ensure that whenever you recompile the kernel that you recompile and install the berliOS driver using: The wireless module a76c503a seem to load and claims to be missing! Hopefully soon Linus atmel at76ca include it in the big one. Issue the following command: